Dependable metal roof installation for Serena homeowners from Roofing Brothers — measured on site, done on schedule, and cleaned up after.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Serena install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Roofing Brothers has been doing metal roof installation since 2002, first around Morganton, North Carolina and now for Serena homeowners through our network of local crews. The standard has not moved: measure it right, fasten it right, and never cut a corner where water can find it.
Before any metal roof installation starts in Serena you will know the price, the material and the schedule. Estimates are always free, and nobody is going to push you to decide while somebody is still standing in your driveway.
How a job actually runs, from the first phone call to the last magnet pass over the driveway.
We measure the roof on site, count the valleys, hips and penetrations, and bring the color chart so you can hold it up against your siding.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Ridge caps, closures, drip edge and gable trim finish the roof and keep wind driven rain and wasps out from under the panels.
Questions homeowners ask us about this kind of work.
Most Serena metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Serena homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Installed properly over sound decking, a metal roof should give a Serena home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
A straightforward Serena house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
What people said once the job was finished and the trucks were gone.
"Burgundy metal roof on our brick ranch and I get compliments on it constantly. They brought the color chart out and let us take our time deciding."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"They roofed our addition and tied in the porch that runs off it. One crew, one number to call, and every line of it matched up."